Traffic Shaping with pf/ALTQ

From Secure Computing Wiki
Revision as of 13:45, 25 August 2008 by Ecrist (Talk | contribs)

Jump to: navigation, search

Sallyport is the traffic shaping bridge for the office. It runs FreeBSD in bridge mode, and uses PF's ALTQ to do bandwidth shaping. It is installed directly between our LAN Firewall, and the Internet.

Why not do the shaping on the firewall?

Good question. Here's the thing: ALTQ has this huge caveat - it can only queue traffic on an outbound interface. That is, say you have the following firewall configuration:

                   (external interface - xl0)                         
                      _________|___________
                      |                   |                           
                      |    firewall       |                           
                      |___________________|                           
                        |               |                            
                 (LAN interface)   (DMZ interface)                    

In such a configuration, you use the external interface to limit upload, but you have to use both the LAN and the DMZ interface to limit downloads. They can't share a queue, and they can't use the same one. Ergo, unless you're willing to hard limit the LAN to say, 66% of your pipe, and the DMZ to the other 33%, you have to do the queuing elsewhere.

Hardware

  • P3 833MHz
  • 512MB ram
  • 1x22GB ATA100
Filesystem     Size    Used   Avail Capacity  Mounted on
/dev/ad0s1a     19G    737M     17G     4%    /
devfs          1.0K    1.0K      0B   100%    /dev

Software

  • FreeBSD 6.2-RELEASE (GENERIC-ALTQ-BRIDGE) #0: Wed Mar 14 14:01:21 CDT 2007

Network Configuration

  • xl0: LAN/Admin Connection
  • xl1: External/Inet Connection (bridge)
  • xl2: Internal Connection (bridge)

ALTQ Configuration

Kernel Bits

This configuration requires Bridging and ALTQ bits in the kernel.

Enable Bridging

Set the following entries in /etc/sysctl.conf:

net.link.ether.bridge.enable=1
net.link.ether.bridge.config=xl1,xl2

Configure PF

Configure pf.conf with two queues to prioritize traffic to the downtown subnets and guarantee a certain amount of bandwidth, leaving the rest to random downloads and web browsing.

# If you're going to change these values, change the sysctl
# variable in /etc/sysctl.conf for bridging!
ext_if="xl1"
int_if="xl2"

# LAN IPs
table <lanips> { 10.0.0.1/24, 192.168.1.1/24 }

# Use the external interface to queue uploads (towards the internet)
altq on $ext_if cbq bandwidth 1.544Mb queue {uploads}
        queue uploads       bandwidth 100% cbq(default ecn)

# queue downloads on the internal interface (*sigh*)
altq on $int_if cbq bandwidth 1.544Mb queue {other, downtown}
        queue other    bandwidth 1Mb     priority 2 cbq(default ecn)
        queue downtown bandwidth 0.544Mb priority 1 cbq(borrow ecn)

pass in quick on $ext_if from <downtown>  to any queue downtown keep state
pass in quick on $ext_if from !<downtown> to any queue other    keep state

pass out quick on $ext_if queue uploads keep state

See Also